Which Tree Disease Treatments Are Recommended for Anthracnose on Dogwood Trees?

Spray a copper-based fungicide on the full canopy at bud break in early spring, repeat every 7 to 14 days through the spring season, and prune out any infected branches during dry weather. That combination treats both the leaf-spot stage and the more serious vascular stage of dogwood anthracnose, and it works best when you start before symptoms appear.

Dogwood anthracnose is caused by the fungus Discula destructiva, which is a different and more aggressive species than the anthracnose fungi that affect maples and sycamores. The disease starts as small tan or brown leaf spots in cool, wet springs (typically 60 to 75 degrees Fahrenheit) and can progress to branch cankers and trunk damage over successive seasons if left untreated.

What does anthracnose look like on a dogwood?

Dogwood anthracnose shows up as angular tan or brown spots on the leaves and flower bracts in late spring, usually following the leaf veins rather than forming neat circles. Infected leaves often brown from the tips and margins inward, and the dead tissue clings to the branch instead of falling.

In a second or third year of infection, the disease moves into twigs and branches. Cankers form where infected leaves meet the branch, dieback works downward, and the tree may push out epicormic sprouts (small shoots growing directly from the trunk), which is a stress response. Once cankers girdle a branch or reach the main trunk, the damage can kill the tree.

How do you treat dogwood anthracnose on the leaves?

Apply Liquid Copper Fungicide Spray ($18.95, 1 pint concentrate) with a hose-end sprayer or pressurized hand sprayer, wetting all leaf surfaces to the point of runoff. One pint treats 5 to 6 large trees. Liquid Copper is labeled specifically for anthracnose on dogwoods.

Start when buds first open in spring, before any spots appear. Spray every 7 to 14 days through spring, using the shorter interval during rainy stretches or if spots are already visible. Continue until the new leaves have fully hardened off, usually by early summer.

In fall (October or November), spray the tree and the ground beneath it one more time. The fungus overwinters on fallen leaves and bark, so this late-season application reduces the spore count going into the next spring. Rake and destroy all fallen leaves under the canopy after spraying. Do not compost infected debris.

What should you do when anthracnose reaches the branches or trunk?

Vascular anthracnose requires a more aggressive spray schedule. TreeHelp's Anthracnose Spot guide recommends spraying at bud break, then weekly until the leaves fully develop, then every 3 to 4 weeks through the rest of the growing season.

Prune dead and heavily cankered branches during dry weather. Sanitize the pruning tools after every cut with 1 part bleach to 4 parts water. Removing infected wood cuts the fungal load, and opening the canopy improves the air circulation that helps leaves dry faster.

For dogwoods too tall to reach with a hand sprayer, Garden Phos with Pentra Bark ($44.95) offers an alternative that does not require drilling or injection. Garden Phos is a phosphite-based treatment that supports the tree's own defense response; Pentra Bark is a surfactant that carries it through the bark into the vascular system. Mix 50 percent water, 50 percent Garden Phos, and 2.5 percent Pentra Bark by volume, then spray the trunk from about 6 to 9 feet above the ground down to the soil line. Apply only while the tree is actively growing.

How can you keep anthracnose from coming back?

Anthracnose thrives on moisture sitting on leaves, so prevention comes down to keeping foliage dry and the tree strong enough to fight off what does land.

  • Improve air circulation. Prune crossing and crowded interior branches so air moves freely through the canopy and leaves dry quickly after rain. This is the single most effective cultural step.
  • Water at the base, not overhead. Use a soaker hose or slow drip at the root zone. Overhead irrigation keeps foliage wet and mimics the rainy conditions the fungus needs.
  • Clean up every fall. Rake and destroy all fallen leaves under the canopy. The fungus survives winter on leaf litter and bark debris, so removing it breaks the reinfection cycle year over year.
  • Support the tree's overall health. A well-fed dogwood tolerates disease pressure better than a stressed one. The TreeHelp Annual Care Kit ($34.95) includes species-matched slow-release fertilizer and a mycorrhizal treatment that supports root development while the tree recovers from anthracnose stress.
  • Choose resistant varieties when planting. Kousa dogwood (Cornus kousa) is far more resistant to Discula destructiva than flowering dogwood (Cornus florida). Hybrid varieties in the Stellar series (crosses between C. florida and C. kousa) also hold up well.

When is the best time to start treating a dogwood for anthracnose?

Early spring, at or just before bud break. New leaves are most vulnerable to infection as they unfold, and preventive spraying during this window protects them before the fungus has a chance to establish. In most of the eastern United States, where flowering dogwoods are most common, that emergence window falls between late March and mid-April.

If you missed that early window and already see spots, start spraying immediately and hold the 7 to 14 day schedule through the rest of spring. Late treatment slows the spread of existing infection even though it cannot reverse damage on leaves that are already spotted.

Frequently Asked Questions

Can anthracnose kill a dogwood tree?

Yes. One season of leaf spots alone will not kill a dogwood, but repeated infections over two or three years can let the fungus invade branches and the trunk. Once cankers girdle the main stem, the tree may not recover.

Should you fertilize a dogwood that has anthracnose?

Yes, but avoid high-nitrogen fertilizers during an active infection. Rapid new growth is especially vulnerable to the fungus. A slow-release, species-appropriate fertilizer applied in early spring or fall supports recovery without triggering a flush of susceptible leaves. TreeHelp's dogwood fertilizing guide covers timing and rates.

Does pruning alone stop dogwood anthracnose?

No. Pruning removes infected wood and improves airflow, but fungal spores travel by wind and rain and can reinfect new growth within days. Combine pruning with fungicide sprays and leaf cleanup for reliable control.

Are Kousa dogwoods immune to anthracnose?

Not fully immune, but highly resistant. In prolonged cool, wet seasons a Kousa dogwood may develop mild leaf spots, but serious branch dieback or trunk cankers are rare. Kousa and Stellar hybrid varieties are the better choice for areas with recurring anthracnose.

Is the anthracnose on dogwoods the same disease that hits maples and sycamores?

No. Dogwood anthracnose is caused by Discula destructiva; maple and sycamore anthracnose come from different fungal species. Dogwood anthracnose is more likely to become systemic and damage the vascular tissue. A copper fungicide like Liquid Copper Fungicide Spray treats all of these anthracnose types, but the spray schedule matters more on dogwoods because the disease progresses faster.